Skip to main content

Meyer Sound Documentation

Operating Instructions Addendum — UMS-SM Single Mount Subwoofer

In this section:
Operating Instructions Addendum — UMS-SM Single Mount Subwoofer
meyer-blue-rule-line.png
needs-work.png

UMS-SM Dimensions with U-Bracket

The UMS-SM subwoofer is a version of the UMS-1P subwoofer with threaded end plates for single-mount configurations with the UMS-SM U-bracket. The UMS-SM end plates are factory-installed (with the U-bracket) or it is also available to as an upgrade option for the UMS-1P. The UMS-SM retains the same acoustical and electrical characteristics of the UMS-1P.

needs-work.png

UMS-SM Subwoofer with U-Bracket

Note

For complete information on the electrical and acoustical characteristics of the UMS-SM, refer to the UMS-1P Operating Instructions.

Important Safety Considerations for Rigging!
meyer-blue-rule-line.png

When installing Meyer Sound loudspeakers, the following precautions should always be observed:

  • All Meyer Sound products must be used in accordance with local, state, federal, and industry regulations. It is the owner’s and user’s responsibility to evaluate the reliability of any rigging method for their application. Rigging should only be carried out by experienced professionals.

  • Use mounting and rigging hardware that has been rated to meet or exceed the weight being hung.

  • Make sure to attach mounting hardware to the building's structural components (studs or joists), and not just to the wall surface. Verify that the building's structure and the anchors used for the installation will safely support the total weight of the mounted loudspeakers.

  • Use mounting hardware appropriate for the surface where the loudspeaker will be installed.

  • Make sure bolts and eyebolts are tightened securely. Meyer Sound recommends using Loctite® on eyebolt threads and safety cables.

  • Inspect mounting and rigging hardware regularly. Immediately replace any worn or damaged components.

The UMS-SM U-Bracket
meyer-blue-rule-line.png

The UMS-SM U-bracket mounts a single UMS-SM sub- woofer on walls and ceilings. The U-bracket has two sets of attachment points that determine how closely the UMS-SM is mounted to the surface. The subwoofer can also be tilted as necessary to affect coverage.

needs-work.png

UMS-SM U-Bracket Exploded View

The U-bracket is factory installed with the UMS-SM and attached to its end plates with two M10, 25 mm knobs and two neoprene washers (placed between the subwoofer’s end plates and the U-bracket).

needs-work.png

UMS-SM U-Bracket Side Attachment Points