Release Notes: Firmware — Milan Endpoint Type 3M
New features
ZX amplifier firmware updated to 3.0.6, 2100-LFC, ULTRA-X80, ULTRA-X82 with MP-1 hardware will automatically update, inrush current at startup reduced, improves AC mains reporting in software
Panther fan algorithm updated, improves low-noise operation
Updated IEEE 1722.1 handling of Milan vendor-specific messages
Milan Endpoint Type 3M is now listed correctly in Hive 1.3.2
Updated error polling and reporting during start up, inhibits nuisance errors
Now discovers the same IEEE 1722.1 controller when it is connected to a different network interface
Updated ULTRA-X80/82 DSP alignment processing
Added brick protection
Skips power module firmware update if the MEP hardware revision is not 2A
Skips the power module firmware update if MEP has an old bootloader
Forces the power module into standby before starting the power module firmware update - confirms the MEP will stay powered while in standby mode
Bug fixes/updates
Fixed ULTRA-X80/82 issues related to spurious rebooting, load fault reporting (Nebra error 203), reporting AC mains voltage low (Nebra error 221), and amplifier temperature high (Nebra error 212)
Fixed PANTHER loudspeaker error code 205 and 206 swap
Fixed issues with detecting the power module hardware revision
New features
Added support for ULTRA-X80/82 loudspeaker models
Bug fixes/updates
Fixed edge case related to AVB locking under certain conditions that required a soft reboot of the Milan Endpoint to continue passing audio